Elan IRDKIT Manuel d'installation télécharger pdf (Page 26)

INSTALLATION MANUAL

H560

1. Turn off the AC power to the unit.

2. Remove the screw located to the right of the

two Line Level Output jacks.

3. Remove the four screws located on the front

cover of the H560.

4. Remove both Multi-Pin Connectors.

5. Carefully ease off the H560’s cover from the bot-

tom, making sure not to bend or break the Line

Level Output RCA Jack.

You MUST be fully grounded before

accessing the H560 PC Board. Open

House recommends the use of a

grounding wrist strap anchored to an

earth ground.

Remove

Screws

Remove

Screws

MUTE SW

J19

No SW

MUTE

Config

DSPK

GAIN

LO HI

EPROM

MIC

GAIN

LO HI

Door Speaker

Configuration

Jumper

Door Microphone

Configurations

Jumper

Remove

Connectors

DO NOT REMOVE OR

DISCONNECT while

system is powered up,

as this will cause severe

damage to the H560.

NOTE:

Connectors MUST be Removed

in Order to Remove Front Plate.

DO NOT

ADJUST!

5. Troubleshooting

This section details the procedures necessary to troubleshoot problems that may arise when

installing or operating the H560. After following these procedures to their conclusion, call

Open House Tech Support at (800-999-5225) if unable to remedy the situation.

These procedures include:



Gaining Access to the H560 PC Board



Troubleshooting Audio, Telephone and Door Station

Gaining Access to the H560 PC Board

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Elan IRDKIT Manuel d'installation Page 26

Commentaires sur ces manuels